Cart0
Total:€ 0,00
Your shopping cart is empty!

Installation


Grey - Car Connector Standalone and original:

 1  Red  12v ignition
 2  Brown  Ground
 3  Black/Red  Brake 12v brake lights
 4  Grey/White  K-Line Only for Gen 1
 5  -  Output 1 (Not used)
 6  Orange/Brown  CAN-BUS Low
 7  Orange/Black  CAN-BUS High
   Extra for Standalone:  
 8  -  Output 2 can be used for RPM output for tacho
 9  Brown/White  Handbrake Ground signal
 10  Blue/White  Speed VSS 12v VSS Speed signal
 11  Green  Throttle position 5v Input
 12  Yellow  Boost pressure 5v Input

 


Black - Haldex connector:

1 Red Power 12v ignition
2 Brown Ground
3 Black/Red Brake signal
4 Grey/White K-Line
5 -  
6 Orange/Brown CAN-BUS Low
7 Orange/Black CAN-BUS High
8 Brown/White Sensor Ground Manual Switch Gnd
9 Brown/White Handbrake Ground signal
10 - Input 1 Not used
11 Grey/Red 5v Supply Manual Switch 5v
12 White Manual Switch Manual Switch Signal

 

Small 3 pin connector – Manual Switch
1 White Manual Switch Manual Switch Signal
2 Grey/Red 5v Supply Manual Switch 5v
3 Brown/White Sensor Ground Manual Switch Gnd


Jumper JP1 CAN-BUS Line termination:

Left Car jumper
Car with can-bus system already have termination so the jumper must be open.
For cars with only the ECU the jumper must be closed

Right Haldex jumper
Needs to be closed